Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 5 of 5
    1. #1
      Join Date
      Aug 2012
      Posts
      20
      Country Flag: United States

      Metal Valve Stems

      I recently purchased 4 Vintage Wheel V45s along with their metal .453 valve stems. These parts do not appear to be made for each other so I am looking for advice here. I emailed VWW with pictures and got no response so I called a few days later. They guy on the phone has my email and is looking at the photos but will not acknowledge there is a problem. He tells me to just let the tire installer deal with it......yeah, great customer service there. The problem is the base of the valve will not sit flat against the back side of the wheel. I do not want to "torque it" until it pulls the the flat to the wheel. I want the valve to fit. Here is the valve stem minus the metal washer and nut. The extra rubber washer if for wheel with a .625 hole.




      Here is a picture of the problem. The curvature of the wheel and the size of the valve stem base are not compatible. Although hard to see the rubber wash is installed here.



      VWW said they never had a problem with other customers. I can't believe I'm the first to notice this. I've spent a considerable amount of time web surfing to find another poor soul with the issue and all I could fine is this happening with a trailer wheel. That guy ground the bottom of the valve stem down to get the needed clearance. I'm hesitating but may do the same deponding on the responses here. BTW I am set on using metal stems vs rubber so my car will pass tech for club racing.



    2. #2
      Join Date
      Oct 2009
      Location
      CT.
      Posts
      742
      I have ried using those valve stems in the past. I had the same issues, they didn't sit flat and would leak. After fighting with them for a while I finally gave up and put regular valve stems in. It wasn't worth the battle.

      Good luck!

      Glenn



      Glenn

      1955 Chevy BelAir
      1951 Chevy 3100
      1987 Chevy Silverado

      My last project....
      https://www.pro-touring.com/threads/...my-72-Maverick!!

    3. #3
      Join Date
      Sep 2001
      Location
      Accord, NY
      Posts
      2,295
      Country Flag: United States
      I understand the track use concern as you don't want a rubber valve stem to melt. I've had good experiences talking with Rusty, the owner. The sales person is being irresponsible. In looking at your picture, you need to either do some grinding or find a different metal valve stem. I wouldn't run that stem as is.
      69 Camaro convertible, 410, M22, 8-pt cage therapy program. SOLD.
      68 camaro - SOLD
      67 Bel Air - New street project with perfect floors, frame and trunk!

    4. #4
      Join Date
      Apr 2009
      Location
      san diego
      Posts
      5,101
      Country Flag: United States
      I had a similar problem, I went to Driverz INC and tested all of their metal valve stems and found one that was close then modified it to fit, basically ground down one edge and rounded it to fit the contour of the wheel lip.

    5. #5
      Join Date
      Aug 2012
      Posts
      20
      Country Flag: United States
      I went ahead and ground the needed clearance into the base of each valve stem and hand fitted each one to its wheel. I then had the tires mounted and balanced. If they do not hold air I will report back.




    Advertise on Pro-Touring.com