Fuel tank construction

[SShep71]

No worries, I know the bulkheads are for strength but the added control of fuel from freely moving from side to side is a plus. I intend for the tank design to be multipurpose, that way someone can take the design and build it for a carborated setup or a non module type of pump i.e. aeromotive, walboro, etc. The extra cost and weight of the additional access ports on top is very minimal. My intent for this other than I want my own fuel system is that I want others that have the ability to have access to the drawings. It turns out that my down time over here is good for autocad drawings plus for some reason autocad is a little escape for me, its almost theraputic. haha I want to draw my own watts link but I cannot get ahold of drawings or dimensions to even begin. My Fays2 is stuffed under the car at paint right now. I was planning on using the Z-shaped braket to hold the corner pickups in place. Right now I have a clamp style mounting ring setup for the module, I am not a fan of the OEW style lock rings.