Dynamat installation

[MoeBawlz]

ive done a lot of dynamat work and definately watch those corners... I like the little roller only cus you can get into smaller areas better. If you arent planning on covering EVERYTHING then just go over all the large areas where there arent welded seams. places where vibration is a real problem.

where your tail lights bolt up to the body, you may want to stick some on the back of the light assembly. Also you may want to cut a small peice out for the back of your liscence plate. You may want to dynamat the inside of the door, on the door skin itself. as well as the outside of the cage underneath the interior skin.

pretty much cover EVERYTHING if you have enough, if not get the important areas, firewall, floor, wheel wells, trunk, trunk lid