Welding table construction advice needed

[raustinss]

Make the casters mount to "s" shaped flat bar out the ends...set the height to whatever is comfortable for you...not what others suggest...remember it really does depend on your height a 6'6" guy would work much higher the a 5'6" guy. The bigger the caster the easier it will roll...weigh the cabinets...use angle iron..weigh it and whatever is going in the cabinets. I bet you'd be surprised as to how much it all weighs. Keep in mind the top can be wood and covered with anything from 10ga. To 3/8"....good luck ryan