81 z28 ls pa-protour

[LUV2XLR8]

Well for the love of OCD, I decided that I wanted my rear calipers positioned rearward to match with the fronts. If anyone knows F-Bodies, they are a staggered setup. I also wanted to run Cal-Tracs and Ride-Tech subframe connectors with a 2" drop spring. Parts were purchased so let the fun begin. Running the calipers reward there was now interference on the passenger shock so I figured I could just cut the shock mount from the Cal-Tracks leaf plate and re weld on the opposite side however that would bring the shock closer to the tire... so can't let that happen seeing as the plan was to run a 285 tire. So, after some searching on the net, I found a shock relocation kit on performanceonline.com (Part #:RSRK7081). This moved the shock from the inside of the tub to the inner frame rail, but, added another leaf plate. Only thing I could do at this point was to cut the and weld the two plates together.



Thinking that I was out of the woods, the 2" drop springs from Summit have a 1/2" smaller ID eyelet on the forward leaf spring mount than factory. Well Cal-Tracs has a press-in aluminum bushing that is to match the factory 2" ID eyelet, not a 1.5"... So, had to take the bushings to work and have them turned down.





Now that I could mount the leaf springs, Ride-Tech subframe connectors were put into position for mock up... Cal-Tracs track bar bolt was just long enough to cause interfearance with the spring pocket.... so everything had to come back out and shaved down.



With everything fitting relatively well, it all went back into the car. Leaf’s fit, sub-frame connectors in, brackets on. So, starting to mount up the backing plates for the brakes, I noticed that the through-bolts for the calipers are just high enough that made them non removeable due to the leaf springs being in the way. I was not going to pull C-Clips and Axles every brake change... so noticed that there are (3) hex head bolts that mount the caliper backing plate... 2 were exposed, one was a tight fit, but I could get to it. So, I cut an Allen down just enough to squeeze in between the leaf and the backing plate.



A lot of work but the end result looks nice I suppose... lol. Up next is to measure and order new rear shocks.