Project Obsession

[Todd in Vancouver]

Just realized I never posted the pictures of the assembled front end and engine with trans bolted on. What an adventure learning to clock the bell housing to the centre of the transmission. I had to go buy a magnetic base set up to find the centre and then install adjustable dowels to get the trans in just the right spot.

There are some great YouTube videos on how to do this so I highly recommend them as the directions were very confusing. At least to me.

Here is the assembly to find centre



Getting that reading just where I wanted it



TKO600 installed and torqued down and hopefully never to be removed again.



Engine and trans installed with everything powder coated and painted and ready to rock & roll