Pullmax P9

[dontlifttoshift]

Look at your lower tool holder. There is a square drive on the left and right hand sides. The other side of them is tapered and that is how you adjust the tool holder front to back and then lock it in place. On the left side of the tool holder it is cut with a wedge and the right side of the tool holder there is a slot. if you back those adjusts out you will see what I mean.



For me it is easier to just have one tool that I can do all of the setup with. The wrench you made is awesome.....however you have to go over the tooling to tighten or loosen. Mine is c shaped....like a spanner wrench for coilovers, the collets really don't have to be that tight. I frequently run the lower collet tight by hand and hammer away.