Results 1 to 7 of 7
Thread: rear shock mount plates
-
06-14-2012 #1
Registered User
- Join Date
- Jun 2010
- Location
- meriden. kansas
- Posts
- 108
rear shock mount plates camaro
Just wanting to take old traction bars off my car and mounts shocks correctly. For my 68 Camaro. Thanks matt
Matt Ditch, 1968 Camaro, Hotchkis Springs, CCP sway bar, Global West control arm bushings, 5.3 with TH400, Boss 338
-
06-15-2012 #2
Full Blown G-Machiner
- Join Date
- Nov 2008
- Location
- Central Indiana
- Posts
- 723
Hey Matt... Give Matt a call at Matts Classic Bowties, they are a vendor here and can get you squared away on those lower shock plates. http://www.mattsclassicbowties.com/
06-15-2012 #3
Registered User
- Join Date
- Jan 2005
- Location
- Appleton WI
- Posts
- 377
Are you looking for the 10 bolt or 12 bolt lower shock plates. I think I have both lying around......
Jim
1968 Camaro --502HO, ATI 10" TreeMaster, Hughes TH400 with Gear Vendor's OD, Moser 12-bolt, RideTech StrongArms and MuscleBar, Chris Alston G-bar rear suspension, 2 1/8" by 4" Lemon's Headers through 3" Pypes X-pipe and Hooker AeroChambers.
06-16-2012 #4
Full Blown G-Machiner
- Join Date
- Nov 2008
- Location
- Central Indiana
- Posts
- 723
Just FYI...there is no difference between a 10 or 12 bolt rear on the plates. Its if you have mono or multi-leaf springs is where the difference is.
06-16-2012 #5
Registered User
- Join Date
- Jun 2010
- Location
- meriden. kansas
- Posts
- 108
I have a 12 bolt under the car that has multi-leaf spring perches on the axle. But I have mono leaf springs that some one welded a spacer too.
Matt Ditch, 1968 Camaro, Hotchkis Springs, CCP sway bar, Global West control arm bushings, 5.3 with TH400, Boss 338
06-18-2012 #6
Registered User
- Join Date
- Jan 2005
- Location
- Appleton WI
- Posts
- 377
Daytonayellaz-You're absolutely correct! It's been a few years since I've had leaf springs in my car and the brain must be getting rusty. :P
Mattdirocz-PM replied to......
Jim1968 Camaro --502HO, ATI 10" TreeMaster, Hughes TH400 with Gear Vendor's OD, Moser 12-bolt, RideTech StrongArms and MuscleBar, Chris Alston G-bar rear suspension, 2 1/8" by 4" Lemon's Headers through 3" Pypes X-pipe and Hooker AeroChambers.
06-18-2012 #7
Full Blown G-Machiner
- Join Date
- Nov 2008
- Location
- Central Indiana
- Posts
- 723
Its all good Jim
I just didnt want the OP to get confused.
Reply With Quote
