Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 5 of 5
    1. #1
      Join Date
      May 2010
      Posts
      95

      Popping Noise During Deceleration

      I drive a 1963 Impala that has a mild 350 in it. Recently I upgraded the exhaust on the car to have Hedman Elite Headers (1 5/8") and 2.5" exhaust flowing through Flowmaster Series 50 low-profile mufflers. The exhaust now exits in front of the rear wheel to allow for clearance for wider wheels. Previously, the car had exhaust manifolds flowing through 2.25" exhaust and cheap "Raptor" mufflers.



      Since the change I've had the issue of a "popping" noise from the exhaust when decelerating. The faster the speed, the louder and more frequent the pops. I've seen lots of explanations for this online, but it mostly centers around newer or foreign cars. The noise is a mild annoyance and I'd like to get rid of it if possible. Is it the carb? Timing? Obviously the new exhaust brought out the issue, but I'm looking for ideas about what might fix it. What do you think?


    2. #2
      Join Date
      Apr 2005
      Location
      Erie, PA
      Posts
      349
      Country Flag: United States
      When my monte did the same, a spark plug wire was touching the headers, causing a misfire...

      http://www.popularhotrodding.com/hot...nte_carlo.html
      Andreas
      President First Gen Monte Carlo Club
      www.fgmcc.com

    3. #3
      Join Date
      May 2010
      Posts
      95
      Thanks for the idea, but my wires are all loomed up. I wish it was that simple!

    4. #4
      Join Date
      May 2002
      Location
      Northern California
      Posts
      10,716
      Country Flag: United States
      just unburnt gasses being lit off by your headers during engine underloading, pretty common in free-flowing exhaust systems. You can try setting your idle with your blades closed a bit more, leaning out your system or add a balance tube.
      MrQuick ΜΟΛ'ΩΝ ΛΑΒ'Ε


    5. #5
      Join Date
      May 2010
      Posts
      95
      I hate to be some dumb about this stuff, but what are the "blades"? And how to do I set the idle to lean out the system?

      I don't think the balance tube will work in this case given the X frame and my need for ground clearance.




    Advertise on Pro-Touring.com