Results 1 to 2 of 2
Thread: EFI reg. mounting.
-
04-23-2012 #1
Registered User
- Join Date
- Mar 2010
- Location
- Alabama
- Posts
- 549
EFI reg. mounting.
Where are everyone mounting their efi reg.? I had it mounted on inner fender when I had the carb setup, but going efi there will be alot more lines. I am going to feed rails from back and had thought about mounting reg. in front of throttle body with a custom bracket. Is anybody doing this? It will only requite one line to go far and that will be return. The front of the rails can loop back into each side of reg. This is on a sbc.
David Butler
"If you're not first, you're last"
67 Camaro Twin Turbo SBC (changing from Blow-thru to Holley HP EFI)
-
04-25-2012 #2
Registered User
- Join Date
- Apr 2012
- Posts
- 2
Feeding from the back to the front, then to the regulator (as you stated) is the way I have mine set up. There are a lot of people running this way without issue. Just remember that the fuel returning to the tank will be “heated” by the engine compartment. If not addressed correctly it will cause the fuel in the tank to warm up as well. Warm fuel = slow car. Enjoy the EFI fun!
Reply With Quote
