Looking for a SBC

[Radlark]

I am looking for a RUNNING SBC and trans to put into my car to get me around preferably located in Socal and looking for something complete (carb to pan) with accessories...I have found a few but I have been too late to pull the trigger not looking for a stump puller just something that will last me for about 6 months. The nes i have found complete ready to go with transmission have been from 350-500 so If you guys have something that you have pulled out of a running vehicle and it still has some life let me know please!

[DJW32]

I have a brand new Chevy 350(I may have put 400 miles on the motor) complete from carb to pan. I also have a power glide hooked to my 327 in my Camaro. the 327 is TIRED though. Also, I'm located in Yorba Linda ( where are you in so cal?). If you were close enough, I will drop the motor off for you.

David

[Radlark]

I have a brand new Chevy 350(I may have put 400 miles on the motor) complete from carb to pan. I also have a power glide hooked to my 327 in my Camaro. the 327 is TIRED though. Also, I'm located in Yorba Linda ( where are you in so cal?). If you were close enough, I will drop the motor off for you.

David

Hi David I am in Fontana, are you selling the new 350 or the 327? When you say tired ...how tired (smoking tired, or just have no balls tired), lol)

[DJW32]

Technically, I would like to get rid of both.

The 350 is brand new.
2 bolt main
Quadrajet Carb ( the carb shop)
HEI Dizzy
New GM starter
I have two different flex-plates for this 350.-1 for a turbo 350 and 1 for a 700R4

The 327 is right out of 1967. It hasn't been run in 5 years.

If I were you, I would have no worries with the 350 (again, brand new motor). I wouldn't be comfortable with selling you the 327, and telling you that it will work flawlessly.

Also, I would deliver the motor to you in Fontana. I hope you have an engine hoist...?

[Radlark]

Technically, I would like to get rid of both.

The 350 is brand new.
2 bolt main
Quadrajet Carb ( the carb shop)
HEI Dizzy
New GM starter
I have two different flex-plates for this 350.-1 for a turbo 350 and 1 for a 700R4

The 327 is right out of 1967. It hasn't been run in 5 years.

If I were you, I would have no worries with the 350 (again, brand new motor). I wouldn't be comfortable with selling you the 327, and telling you that it will work flawlessly.

Also, I would deliver the motor to you in Fontana. I hope you have an engine hoist...?

pm your asking price please

[DJW32]

Pm sent.

[daytonayellaz]

Man...if you were closer, I have the perfect package for you. Its a fairly fresh 350/350 Turbo. Breather to oil pan, all accessories, new water pump, new alternator. It runs reallly good! Im getting ready to pull it out to do a LS2/4L70E swap. You could actually hear it run until I pull it. I have a great freight co. to ship with, but that may put it over the top ??