Results 1 to 8 of 8
Thread: DSE Tub Quesion
-
10-22-2011 #1
Registered User
- Join Date
- Feb 2007
- Location
- USA, TN
- Posts
- 850
DSE Tub Quesion
I'm installing my DSE mini tubs in a 71 Nova. I've got the old one out and compared it to the DSE tub. It looks like the DSE tub is 2 inch deeper than stock, but the instructions are telling me to cut 2.5 inches. Is this correct?
-
10-22-2011 #2
Starting The Transformation
- Join Date
- Mar 2006
- Location
- New Carlisle Ohio
- Posts
- 245
Originally Posted by TnBlkC230WZ
Yes. 1/2" will be bent down as a flange to fasten the deep tub too. Keep reading the instructions and watching the video. There are also several good pictures from others here that have documented the install, try a search. The more you study it, the more it will make sense. It's alittle intimidating but just keep at it and you'll get it. Once you have one fit, the other will go together quick.PartTime
Chris Hager
10-22-2011 #3
Registered User
- Join Date
- Feb 2007
- Location
- USA, TN
- Posts
- 850
Sorry, but the question is are the tubs 2 inches deeper or 2.5 inches deeper than stock?
10-24-2011 #4
Registered User
- Join Date
- Dec 2010
- Location
- Fredericksburg, VA.
- Posts
- 3,164
I think the instructions are a bit unclear. Even with the CD and instructions I still had to call DSE. You might be wise to give them a call before you cut just to make sure you understand.
10-24-2011 #5
Registered User
- Join Date
- Feb 2007
- Location
- USA, TN
- Posts
- 850
Good idea. There seems to be a disconnect in the actual depth of the tubs. It could be my imagination though.
10-25-2011 #6
Registered User
- Join Date
- Jul 2007
- Location
- Los Angeles, CA
- Posts
- 1,303
Whether its 2" or 5" doesn't really matter. You want to start very short and try to get the new mini-tubs to fit. Then look at where its not going in and slowly trim back, rinse and repeat until you can *just* barely get the tubs to fit in. Cutting anything more will leave an unwanted gap. The tricky part is the spot where you have to fold down a section of the floor to make a lip. Hopefully you have the DSE templates and can confirm the measurements from DSE.
Just in case you haven't seen this thread - Novice's Mini-tub guide:
https://www.pro-touring.com/showthre...a-68-69-Camaro
10-29-2011 #7
Registered User
- Join Date
- Dec 2010
- Location
- Fredericksburg, VA.
- Posts
- 3,164
BTW, Ed that was a great write up you did!!!
10-29-2011 #8
Registered User
- Join Date
- Jul 2007
- Location
- Los Angeles, CA
- Posts
- 1,303
Thanks! Originally Posted by TheJDMan
Reply With Quote
