Show Off Your Motor

[86Cutlass383SR]

Since they don't need to actually be IN the car ... (hoping it will be before the snow starts flyin though ....)



383 with AFR heads, 230 236 113* hyd roller cam & roller rockers, Accell SuperRam intake, 30# injectors, ...

[Procharmo]

This is a poor boy's big block. SBC 406, AFR 235's, 2 x Procharger F1C, AMS1000 boost control....all in a rusty 2nd Gen Protouring Camaro.

New Carb



New 5th Radiator

New wastegates.

[critter]

My goodness! That's a lot of braided line there.

[ZYAL8R]

383 SBC

[absintheisfun]

My toys:

In my Typhoon


In my 63 C10...after the mouse nests were cleaned out!


In the Camaro--yet to be started :(

[85GPLEf41]

Well since it's not a requirement it to be installed here is my lowly LS1 from a 98 Firebird Trans Am...in the beginning stages.. hoping to get a solid 400 horse's from it.lol!

[MOTRUBL]

423" LQ9, backed by a T56, in my old '98 Z/28. It made 618hp.

[dcpetty]

Here's mine on my break-in stand. I am in the middle of a full frame off resto on a 67 Camaro.[/IMG]

[1969CamaroRS]

Going together:


Completed motor ready to fire up for first time on a stand:


Just dropped the motor in:


Getting closer:

[rfalker1]

Not quite American lol, will upgrade with some carbon

fiber

and for the goodstuff, my 383 stroker

/>

but which air cleaner

[JustinB]

Here is a shot of my motor on the dyno.

[Procharmo]

My goodness! That's a lot of braided line there.

Thanks. It wouldn't have been the same with rubber and worm gear (jubilee)clips. But then again if I had skills it would have been off the hook with stainless steel hard lines ...LOL!!!

[demon1515]

[carguykeith]

Not much BOP stuff on here so this is my 488 Olds.


Long block done.


On the stand



In the car

[Twin_Turbo]

a 301 LOL

[r.a.w.rods]

05 300c I just sold.


70 Duster 225 SlantSix

[Poorhousenext]

[cencalc6]

Great looking engines

[Mr Nick]

Not much BOP stuff on here so this is my 488 Olds.

Finally an Olds in this thread!

[zipsimons]