Mil-Spec Bulkhead Connector

[Gandalf]

I used this http://www.eficonnection.com/eficonn...spx?ItemId=761. Its mounted where the heater motor was.

I just received my one of those 30-way bulkhead connectors from EFI connection last week - just be aware this thing is humungo! Check the outter dimensions before you order. I will use it if we can find a decent way to package it. I went this direction is because I am trying to pass my entire LS engine harness through the firewall (hidden in trans tunnel). That includes the coil-pack wiring which I'm told can spike close to 13A so this is the only one I could find that would support that. I'm now considering splitting the harness and passing through using two smaller connections - one like the XRC one JohnP mentions for low power and something else for the few higher power circuits.

Based on what I have seen, I would definitely do the XRC connector for what you are looking to connect.

Gregg