Results 1 to 4 of 4
Thread: Linkage Pics
-
03-09-2011 #1
Registered User
- Join Date
- Mar 2005
- Location
- Woodbine, MD
- Posts
- 2,770
Linkage Pics
I am having some issues setting up my throttle linkage on my new 4150 holley. I am trying to find a throttle stud that will fit my stock cable and fit in one of the holes on the linkage...
Can you all post up some pics on how you have your throttle cable/linkage set up?
Douglas Lutes
1988 Monte Carlo SS
"Never race anything you can't afford to set on fire and push off a cliff."
-
03-12-2011 #2
Starting The Transformation
- Join Date
- Nov 2006
- Location
- NH
- Posts
- 269
Doug,
Can you post a pic yourself of what you got and trying to do?
JeffSHAKER TUNED SOLUTIONS
03-12-2011 #3
Registered User
- Join Date
- Mar 2005
- Location
- Woodbine, MD
- Posts
- 2,770
I will in a little bit. All I am trying to do is figure out what hole on the holley bracket to use for the throttle stud. The upper most hole is big and is used for the return spring. The lower most hole is used for the kickdown cable. This leaves about 4 holes for the throttle stud but my stock on was too big. I went to as local speed shop and got an edelbrock one that uses a cotter pin instead of the c clip thingy. This should work. I just was looking for some various pics of what people were using for the throttle stud/cable.
Originally Posted by Shaker455
Thanks!!!Douglas Lutes
1988 Monte Carlo SS
"Never race anything you can't afford to set on fire and push off a cliff."
03-13-2011 #4
Starting The Transformation
- Join Date
- Nov 2006
- Location
- NH
- Posts
- 269
I don't use the upper half of the throttle lever for a spring return as it's intened to be used on the bottom half with the spring comming from the back...mech advantage.
Normally the throttle cable stud goes in the second largest hole in the upper half of the lever.
The big hole is not often used but there are kits out there that have parts to fit in the large hole to reduce it to a useable size.SHAKER TUNED SOLUTIONS
Reply With Quote
