Results 1 to 8 of 8
Thread: Demon problems
Threaded View
-
06-06-2005 #6
Well, first of all, put some real spark plugs in it like NGK's.

Yeah, check the power valves. Suck on the end opposite the spring and stick your tongue to the opening...if it holds vacuum, it's good. And gas tastes good.
Demon carburetors are NOT Holleys! They don't tune anything like a Holley....in a good way. They are VERY sensitive, and need to be tuned accurately, and in very small steps. As an example, don't turn the idle mixture screws anymore than an 1/8 turn at a time.
Set transfer slot exposure to .040" primary, .020" secondary, and as you adjust curb idle mixture and the idle speed changes, use BOTH primary and secondary curb idle screws to adjust RPM. Again, this is very sensitive.
You may have to change the idle air bleed size too. We've had to with every Demon we've run. They sell press-in restrictors if you need to go down in size, but if you need to go up in size you have to drill them out.
If you get this far into tuning, I'd suggest getting the Demon book. It's pretty thourogh.
-Matt
Welders: The only people that think a co-worker catching on fire is funny.
-





Reply With Quote



