lower a-arm geometry

[rrelco]

There are only two ways to get the lower ball joint below the pivot point: 1> raise the pivot point (not practical).
2> more loaded spring height (either with taller springs or added spacers).


A taller spindle would require a taller spring to drop the lower arm (IMHO)

QA1 has 1.0 inch spacers only not longer conical springs, Blake at Speed tech wants pictures so he can see whats going on. but thanks i do think if i put the spacers this might help, Blake did say that the ATS are a 7/8 drop so all this and lower a-arm pocket mounts may have added up to this problem.