2nd Chance Camaro - Let the Project Begin

[syborg tt]

I am running an additional power & ground on the passenger side of the car. In order to keep everything neat and tidy I am running the wires inside the Holley Power/Ground wire loom.



In order to stabilize the wire loom I ran it through the grommet which I wrapped with Tessa Tape which was then covered with 3m Electrical tape to give it a finished look.






I didn't want a power source in the cabin so I choose to move it into the cowl panel.
Which should keep it out of harms way and still be easy to access.



I used a couple more Weld Studs to mount the power stud.




While the epoxy was curing I started working on the four optional wires that the Terminator X can trigger.
My thought is it is much better to run it now then figure out how to do it later.



I cut all four wire to an equal length and then installed a different color heat shrink on each wire end so I would know which one is which at a glance.







I also labeled a couple more wires while I was there.





There is a lot going on in this area and when it is finished will be easy to service. I hope !!!



Since I have an early version of Holley Terminator X I have to trigger the transmission signal with a relay.




More notes. This one is reminding me to replace the ground stud with a brass bolt.




I am also working on a solution to keep the coil harness out of harms way and look nice.

[syborg tt]

Being honest the weather was so perfect that I spend the last 10 days riding.







I also purchased a nice small heat gun which only gets hot enough to shrink the heat shrink tubing.










I finally started working on the ground stud.





Picked up a couple more parts.





I will be using this relay to trigger the fuel pump.

[syborg tt]

While I was at Good-Guys Columbus I ran into a gentleman that found an over the counter radiator hoses solution that may work in my car. I ordered them up to see how close they would be on my car and they look pretty good.








The lower looks good but it will need a swivel neck for it to work correctly.

[syborg tt]

Seriously, I forgot how nice these look.








Plenty of room to seal off the cowl panel and install a set of shallow mount speakers.

[TANKMASTERJ]

While I was at Good-Guys Columbus I ran into a gentleman that found an over the counter radiator hoses solution that may work in my car. I ordered them up to see how close they would be on my car and they look pretty good.








The lower looks good but it will need a swivel neck for it to work correctly.

Marty
I think those radiator hoses do go pretty good. You got alot more clearance than I do. My ac compressor to fan shroud is only 2.75 and my water pump and other vicinity pulleys about 3.5. I'm running a c and r radiator, had the high profile fans but had to order mediums. I just test fit and it's tight but I'll have about an inch between fans and the tightest pulleys. I sety dingo sliders and Speedtech engine stands back as far as both would go. I should have re fabbed them like everything else but I'm tired of redo and hard charging forward.
Jason