Car code question

[SDS MACHINING]

Thanks everyone for your help, it appears to be correct. I will check on the VIN to clarify the engine.

[AintQik]

Can't really tell if its an RS from the plate. Check the RS stuff and look for the relays, the harness and the washer tank, little stuff a guy swapping would probably over look. Also look behind the back up lights. It will be a stamped hole not a cut one. The tail pan is a little tough to replace if you were just going to "add" RS stuff so most would just cut the holes not remove spot welds and replace the whole tail pan.

However, if the car was restored and that tail pan was bad, there is no RS replacement so it might be cut and not stamped. You would have to ask the guy if it was replaced after you looked.