Results 1 to 20 of 39
Thread: Datsun 240Z
-
05-08-2005 #1
Registered User
- Join Date
- Aug 2004
- Location
- Maine
- Posts
- 594
Datsun 240Z
Well, I've been mentioning the plans for this project for a few months on this site... now, it is time to start!
I went and picked up the new project car on Saturday... a 1973 Datsun 240Z. It is just a rolling chassis... only the body, suspension, tires and steering. But, it only cost $150 and it is pretty solid.
So, the plan...
1. customize the body by hand-sculpting some fiberglass body panels... staying true to the spirit of the Z, but allowing a little more room for some big tires and widening the track width a few inches on each side.
2. build a complete triangulated spaceframe chassis from scratch.
3. design and build custom front and rear suspension and then add brakes and steering.
4. plop the modified Z body down on the spaceframe and then put together the floor.
5. Install a healthy forced induction FI small block backed with a 6 speed manual trans and rear geared for high speeds.
6. slap in an interior.
7. try to reach the 200mph barrier...
Let the fun begin!!!
For some pics and a writeup of the project, check out my website. Click the link in my sig' and click the "Project Racer-Z" link. I'll keep updating as I get work done.
If you try the page and it says I've exceeded my bandwidth... forgive me. Geocities shuts me down for an hour or two when I get too much traffick.John




Reply With Quote