67 Camaro - Dad and Son build

[RonJitsu]

I see you're selling some stuff. You have any updates planned?

[boostin05blacksti]

I see you're selling some stuff. You have any updates planned?

Sorry for the late response..yes I do.


So I figured out after some talks with jegs that weld makes closed end lugs that can be used with the studs I already have. So I ordered them. In other news we had a nice day in January so I took the car out. It started to stumble and the idle was acting up a bit again. Nothing like before but it was bothering me. I called my tuner up and talked to him and started to do some reading. Well many on the forums really have good things to say about the holley efi setup. I started looking around and the Holley HP EFI kit seemed like the best fit for me with the exception that it doesn't accept DBW. So I talked to holley and if I wanted to stay with my current setup id have to step up to there dominator setup. Searched a bit and found a used setup on craigslist. The ecm was brand new in the box but the wiring had been used. So I made a deal and pulled the trigger. I sold off my old setup and pulled everything out and have spent the last week installing the new harness and rewiring everything to look clean. I can say I am very impressed with the system. The user face is so easy it makes me feel like a tuner. I got the car to start two days ago without a tuner to assist me which says a lot. My tuner is coming tomorrow night to put the final tune on it so ill have it ready for this upcoming spring/summer. No dyno time at this point just doing a road tune and some WOT pulls so I can hit the track also. Next up for the car is installing the level sensors for the airride and I have talked to a buddy about notching the rear 4 link bar to make some more room for the car to go lower in rear. Stay tuned..




I also finally did an actual bolt up of the welds.