Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 1 of 1

    Threaded View

    1. #1
      Join Date
      Aug 2004
      Location
      Melbourne, FL
      Posts
      1,046
      Country Flag: United States

      Wheel well repair??

      I'm getting ready to fix the crappy job I did years ago on my rusted out wheel wells. My quarters are in overall pretty good condition so I didn't want to replace the entire quarter. Plus we moved my rear end back about 3" so my top would close with full tubs installed. So now my wheelbase is about 3" longer than stock so full quarters don't line up. I used the three piece patch panel years ago and did a crappy job. So I went ahead and picked up a set of quarter skins so I can just cutout the wheel well area and weld that back in amd have a nice round wheel well.

      So, my question is what's the best way to cut out the area from both the original quarters and the skins so I get a nice fit when I go to weld it up. I'd like to do a butt welld but and not opposed to a lap weld if that would be better for this situation. I assume if I did a lap weld to make the flange in the new quarter skin and put it behind the stock quarters. I'm not a expert welder but do pretty good.

      Any thoughts/suggestions would be appreciated so I get it right this time around.

      67 Firebird Convert 455 +.060 Johnny Winters TH400 74cc KRE d-port flowed @ 310 cfm heads piston dished 16cc H-beam rods Comp Cam 305-AH-8 cam 108* LSA 253/260 @.050 duration .577/.594 lift w/1.65 rockers Ford 9" 3.55 Detroit Locker M/T Sportsman Radials 31x18x15 on Convo Pro 15x15s

      Honest dad that 455 on the side of the block is a serial number



    Advertise on Pro-Touring.com