Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 11 of 11

    Hybrid View

    1. #1
      Join Date
      Apr 2001
      Location
      Central CA USA
      Posts
      6,114
      Country Flag: United States
      For a first time alignment you can first establish a center line under the car. Drop plumb bobs-down from measured center points front and rear, run a string line under the car front to rear to establish an accurate centerline. Measure out from the center line to establish your string lines at axle height along each side of the car. It is much better to bolt or clamp a piece of tube across the front and rear to hold the strings. This is how the Indy car guys do it at the track, and you can jack up or move the car with this setup and not have to move the strings. On a leaf spring car, a straight edge or piece of tube can be placed against the sidewall of the front tire and you can measure or sight in if it's parallel to the rocker rails of the car. This is how I used to do it. Lately I've been placing a 2' laser level against the side of the front tire and pointing it rearward. It either hits the rear tire edge, or if it misses it, I place something up against the rear tire so the laser can hit it. This helps me set the front wheels pretty close to straight ahead when taking bubble gauge readings. I like to set camber, then caster, then recheck camber, all with a quick laser check to keep the wheel pointed straight ahead, then I use the toe plates to set toe in. This usually get's me to within 1/16" steering wheel turn of centered.

      Roller plate turntables are nearly a must to get accurate turn angles for caster readings. A small error in turn angle will mess up your readings. The car should have it's wheels up on 4" to 6" tall blocks to allow enough room to get underneath and reach the toe adjusters.

      Last edited by David Pozzi; 04-08-2010 at 09:04 PM.
      67 Camaro RS that will be faster than anything Mary owns.


    2. #2
      Join Date
      Nov 2008
      Location
      So. Cal.
      Posts
      1,240
      Country Flag: United States
      Hey David, thanks. Good info!! I already have centerline hard points set on the front and rear X-members from when I installed the art morrison 4-link rear clip. I should prolly go off of those points. I like the tip on using a bar that rises and falls with the car during suspension changes. Thanks for the tips.. JR
      What I write is opinion, none of it is factual. 2010

      Even though I'm conscious it doesn't mean I'm coherent. 2011

      I'm getting better with age. Best thing about old age is I don't know any better. 2012




    Advertise on Pro-Touring.com