Need some spec's

[CamaroAJ]

well the torque tube would need a CF drive shaft. the aluminum flexes too much and will come in contact with the outside tube. found that info on corvette fourm, they also said stock it almost contacts as it is.

not sure about the narrowed part, i can tell you that the rear has to be cut on both sides because of how the transmission is mounted and the front can just be cut in the middle.



also another issue you run into is header clearance between the frame rails and block.

if you do a search on here there are about 6-12 cars that people have started this project on back to 05' and not one is close to being done. thats why i changed my plans of a C5Z swap and bought a subframe, the track data from the optima shootout had a few vettes in it and they were beat by subframe and rear suspension moded cars.