Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 11 of 11

    Hybrid View

    1. #1
      Join Date
      Aug 2004
      Location
      NY
      Posts
      1,070
      You should give a bit more info on what materials you used and what colors you have shot to get an accurate answer.

      You shouldn't be sanding a base coat and can actually cause problems by doing so. The clear window is kind of a guide although I probably would scuff and reshoot a light coat. It depends on what base you used?? Catalyst or just reduced? Base coats should only be applied to provide coverage not to build or create a shine unless you are clearing a single stage paint??

      The least coats is always the best as the more you apply the more chances of reaction or dirt in your paint. If you are seeing dirt in your base it will be 10x in clear so start cleaning where you are spraying.



      Read tech pages and don't go by general info on the internet.


    2. #2
      Join Date
      Dec 2004
      Location
      Tulsa, OK
      Posts
      112
      Quote Originally Posted by BRIAN View Post
      Read tech pages and don't go by general info on the internet.

      That's the best answer right there, as I was going off of DuPont's product line and he now states he's using SW. Also the tech sheet shows a 7 day window instead of 12-24 that DuPont allows. I would also search the internet for SW tech sheets for all the materials you used, not just the base clear.

      1980 Z/28 383, Vortec heads, 2004R 342.1 powertrac
      1971 Firebird on rotisserie
      2006 Dodge Daytona Charger
      "Torred" # 1988 of 2000
      2013 Hot Wheels Edition 2 SS Camaro
      "I'm Not a Gynecologist, but I'll Take a Look"

    3. #3
      Join Date
      Mar 2008
      Location
      Ramona, Ca. San Diego area
      Posts
      1,307
      Country Flag: United States
      I agree, read the specs given to you for the material you are using.

      You dont want to use all the paint just because you have left over. All you need to do is cover the car evenly. Base is just color behind the clear. Your clear is what you want thicker.

      Sand what you have with 800 grit. Anything less will have scratchs that you will have a hard time with. To fine of sand paper is not good either.

      Once you have it sanded, re-shot the base and by the time you clean your gun and mix your clear up your base will have had time to flash.

      Fix any small blems by wet sanding very carefully and spray your clear.

      Skip this next step if you dont need it perfectly flat.
      Dark colors really benifit from this step.

      Put at least 3 coats on it and wait for a day or two and wet sand it with 600 with the longest board for the panel. What this will do is level the clear and base perfectly. You are not doing this to get rid of orange peel. This step is to make the panel perfectly straight.

      Then re-clear the car with a couple more coats. Let dry to specs and cut and polish it.


      This process works very well.



      sanded after paint





      After re-clear and cut and buff.




      Is this what you are looking for?

      67 Camaro convertible (Jinx)




    Advertise on Pro-Touring.com