Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 20 of 27

    Thread: Diy - fail

    Threaded View

    1. #21
      Join Date
      Aug 2004
      Posts
      540
      Quote Originally Posted by Jim Nilsen View Post
      The load on a rag joint is probably not a lot with power steering until you hit large bumps or impacts and that is why a rag joint is there to begin with and are easily and cheaply replaced by design.
      I tend to agree, the largest input I can think of is that of the strongest person you can find, turning the steering wheel to full lock as hard as they can -- any misalignment could create additional stress in the entire assembly which may result in binding.

      Given our friend has modified the bolted joint by eliminating two of the shoulder bolts, I am not quite sure how it would behave compared to stock in the event the isolating material fails. In stock configuration the joint is designed to continue working even if the isolating material (rubber) disintegrates, which it tends to do on 40 year old cars.

      Regarding True's thoughts on work hardening, work hardening is a result of repeated plastic deformation as a result of loads being greater than the yield but less than ultimate tensile. I think the disc would begin to delaminate before any failure of the aluminum. If the bolted joint was maintained in OEM configuration, with the exception of the new disc, it could result in a loss of clamp load in the joint manifesting itself in sloppy steering; given the change in bolted joint design, the fasteners and the design of the joint should be scrutinized.

      I certainly don't endorse this guy's efforts, but it is an interesting engineering problem.






    Advertise on Pro-Touring.com