Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 4 of 4
    1. #1
      Join Date
      Jun 2006
      Location
      Katy,TX
      Posts
      1,678

      Zinc washed rotors

      I've got some cast iron WS6 rear rotors I'm using on a project new. What options are there for keeping them form rusting-home Zn washing?

      I painted with high temp pain another set but even a light dusting we had to sand it off the mounting surface as it gave the rotor runout.



    2. #2
      Join Date
      Jan 2006
      Location
      Oregon
      Posts
      1,773
      Country Flag: United States
      I've seen home black oxide kits, but not Zinc. The issue is that it's an electro-plating process, so without the current and the tanks and chemicals, you'd be hard pressed to do the real thing. You might call around and see if there's an industrial electro-plating company near you that would run a small batch of rotors for you. Most will want you to strip any paint first so it doesn't contaminate their tanks. Zinc chromate is available in several colors with yellow and clear (silver) being the most common, blue, black, and olive drab being less common. You want a minmum coating thickness of 200 micro-inches for max corrosion resistance. Cadmium plating is another option, albeit more expensive and less common due to the heavy metals regulations.

      I've had some customers swear by electroless nickel, but have some concerns about bedding in the rotors due to the inherently higher strength (and heat-treatability) and abrasion resistance of the nickel versus zinc or cad. The nice thing about nickel is that it isn't an electro-plating process, so the plating thickness tends to be uniform regardless of the geometry of the part, whereas electro-plating relies on voltage differences in order to deposit material, so holes and areas between the cooling vanes tend to get less coating due to the eletrical fields imparted in such geometries.

      Just my $.02 for what it's worth.

      Tobin
      KORE3
      It's what I does.

    3. #3
      Join Date
      Jun 2001
      Location
      Newbury Park, CA
      Posts
      5,839
      Country Flag: United States
      I had mine zinc coated at a local electro-plater.
      VaporWorx. We Give You Gas http://www.vaporworx.com

    4. #4
      Join Date
      Sep 2006
      Location
      Southern Indiana
      Posts
      4,709
      Country Flag: United States
      One : you must not paint,plate,coat the mounting area,
      two: unless its a zinc wash, dont get it on braking area without remachining, I really dont eve like it on wear area as it has some issues during pad bed in, last 2 sets installed at work I found where pads wore and turned the zinc off (minimal cuts like 0.002 to 0.003 on each side) as the car just wouldnt stop for crap, did that, used 50grit emery paper (cloth backed stuff) to sand pads on flat surface and tada brakes worked much better, instructions even said braking would get better as coating wore in/off.
      The black cad plating kit from eastwood uses a small battery or car battery. Otherwise paint everywhere BUT wear and mounting areas with caliper or VHT high temp header paint works great




    Advertise on Pro-Touring.com