Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 9 of 9

    Thread: Power bleeding

    Threaded View

    1. #9
      Join Date
      Sep 2006
      Location
      Southern Indiana
      Posts
      4,709
      Country Flag: United States
      OK first of all you have mostly filled system, place lots of rags under master cylinder and around, loosen the lines at the master cylinder so lines are loose but dont remove nut, have partner push pedal to floor slowly or you make mess and get fluid everywhere and its loves to eat paint.
      Do it 3 time for each side, then start this way, if its disc start on right rear, and have partner pump pedal not fast just down, up, down, up, down, up,down and hold it, they say ready, you open bleeder, 1/4 turn should open it fine, close before done running.
      Do it 3 times at each wheel.
      Also make sure it brand new fluid from sealed container. Now pump it up 3 times, and hold, try to feel it sinking if not and fluid was clear of big bubbles your good to go, if it has new pads and rotors till you drive it few feet and get pads settled and all it may feel spongy. I have done brakes for over 20 yrs and they still scare me on first few stops.
      Also on new pads seem to have a rough surface but it was ground and has valleys and peaks and may not make perfect contact till rubbed few time by rotors.
      AS for bleeding I love my Phoeneix Injector, for reverse bleeding, if changing master I reverse bleed up to the master cylinder, then bench bleed with my Phoenix Injector.






    Advertise on Pro-Touring.com