Results 1 to 14 of 14
Thread: burn through?
Threaded View
-
05-15-2009 #10
Registered User
- Join Date
- Dec 2006
- Location
- Cypress, TX
- Posts
- 330
When you prep the panels, did you use 2" or 3" disk? It's easy to cut to far in the panel and thin it out.
What pressure are your gauges set at now? You might try adjusting the gas pressure (Higher). I have a mm251 and I have to run higher gas pressures on thinner metal.
I have a roof panel if you want some pratice metal to try to get your welder set up.
-
Reply With Quote
