Rear body panel, 69 Camaro

[69Myway]

Okay Mr. Quick,

I will get the panel, trim it down and install. Post pics.

If the left over part is what you need, then we can figure out a quick inexpensive way to get that to you.

What bites the big one, is I just finished cleaning, prepping, and shooting the entire inside of the truck in bed liner textured spray. That includes the inside of the rear panel around the tail lights, etc. "IF" I decide to rip the whole panel out.....I have to go back and grind through the textured spray to get a good surface for spot welding, etc....

BTW, There was NO rust in this panel. Just some major collision damage of some kind. They had drilled a couple dozen holes in it to pull it out and get a bonding surface.

Here is the funny part. My memory obviously fails me, as I am finding bondo between the factory finish, and the paint job we put on it in 1985, then...there is more filler on top of that under the grey primer that was on the whole car when I found it and brought it home.