Subframe Alignment Issues

[SSL]

Sounds like I might have caused a little confusion... The rear end is aligned properly and the rear wheel fender gaps are perfect.

When the subframe was installed, I did use the alignments holes to align it but it seemed to be a gross alignment method.

The front fender-to-tire gaps are not the same side-to-side. Using a straight edge across the front wheel openings (at the mid-point body line), the passenger side has about 1/8" gap and the drivers side is about 1/2".

With the subframe loose, I wonder if the subframe-to-body alignment holes could be used to move/pry the frame into place?