Results 1 to 2 of 2
-
05-29-2008 #1
Registered User
- Join Date
- Jan 2008
- Location
- Castro Valley, CA
- Posts
- 530
Steering Column firewall Grommet Q's
OK so my firewall was redone and is now just a flat piece of sheetmetal. I need to figure out what to use as a grommet for the steering column hole. I know Ididit has a chrome one but its 110$ or so. Maybe some rubber trim? Or maybe no grommet?
Secondly, would the hole need to be oval shaped since the steering column is in at an angle? Thanks
John S.
68 "Bloodline" Camaro in assembly...
Speedtech Sub, Alston G-Billet/Fab 9 rear, Ridetech coil overs, Moser axles, Fesler 19's, Lots of Anvil parts,Twin tubo LS3/T56, Carbon fiber manifold, and the list goes on and on..........
-
05-30-2008 #2
Registered User
- Join Date
- May 2000
- Posts
- 4,151
I used one from Billet Specialties. I liked it because it was only $60, and it didn't have any exposed bolts.
These types are better then just a grommet, as they ad support as well.
Reply With Quote
