Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 17 of 17

    Hybrid View

    1. #1
      Join Date
      Aug 2004
      Location
      SoCal
      Posts
      1,008
      Color will be black, like my avatar pic. I was going to panel paint but I'm really nervous about scratching everything to hell when I try to re-assemble. That's why I want to try putting everything off and on a few times to see how it goes. Plus if I paint myself, my compressor isn't going to be large enough to paint the whole car assembled.



    2. #2
      Join Date
      Nov 2003
      Location
      Maine
      Posts
      1,076

      paint

      like happy says that is the best way to do it, but a straight panel is a straight panel, you just have to know how to feel the panel, and watch the material when sanding, however i would assemble car and just paint with doors off, that way fender jamb and door jamb will have no taping, then 4-5 days later tape edges of jamb up with 2-3 layers of tape and install dorrs with a trusted friend, if you do not do body work for a living i would not worry about block sanding the car with all panels on,. however having as much on the car as possible will eliminate chips and scratches, a few layers of masking tape will save you, goodluck
      jake

    3. #3
      Join Date
      Aug 2004
      Posts
      282
      Lord dont do bodywork on those repo's off the car ...they will not fit after that...I did a 69 with "repo" fenders and bridged and made gaps had everything perfect as one could get with the POS ...took them off, primed them and blocked them on a stand and just blocking them warped the bow contour on the side, the one that is adjacent to door...had a hellva time getting the panels to line back up again. Just my opinion, I would far rather have patches welded in GM stuff than those fenders, doors or trunks. The quarters are sorry too but atleast your cuting and fitting them anyway so you can doctor them to fit.
      GOOD LUCK...

    4. #4
      Join Date
      Feb 2005
      Location
      Oklahoma
      Posts
      7
      An easy way to see what your painted panels will look like ahead of time is to use a wax and grease remover. Wipe it on the panels and it will wet them and give a great shine, this is what your panels will look like after paint. Paint gives gloss but will not hide anything. this trick will work after primer is dry and you start blocking. As far as painting apart if I was going to paint a car black I would try to do it in pieces but spray everything inthe same session. Just my two cents, and they are worth just what you paid for them!

    5. #5
      Join Date
      Nov 2003
      Location
      Maine
      Posts
      1,076

      68fusion

      sounds like your a little heavy on the block sanding, man take it easy, or support the part being blocked properly so it is not bowing when blocking it out, the urethane primer and polyester i use sand very easily
      oh yeah, i would highly reccomend polyester primer for your car, it will straighten hail damage to an extent, the good stuff builds 40-50 mils in 5 coats, block with 180-220, then urethane prime and block with 400-500, now your ready for paint
      jake




    Advertise on Pro-Touring.com