$5000 budget Mustang

[BADDRIDE II]

Does all your stopping going thru those 5 5/16 attachment bolts?

Those five RA bolts would not be any problem at all. The outer tapped aluminum BAER "hat" would be the weaker of the two IMO.....but even these I doubt would ever be any problem, and if they were they could be enlarged to the next bolt size providing even more strength.



Ron, just a suggestion but from experience I have seen snouts move slightly from originally installed "straight" or "cambered" position from putting this much heat so close to the tube/snout end, if one snout moves slightly one way.....and the other side moves the other, it could definately be enough to cause premature wear on drive plate/axle spline/diff spline. May want to double check "through alignment" if snouts were originally installed straight to verify perfect alignment? Good luck!