Results 1 to 3 of 3
Thread: Russell Full Flow AN hose ends
-
01-05-2008 #1
-Moderator/Sponsor-
- Join Date
- Jun 2001
- Location
- Newbury Park, CA
- Posts
- 5,837
Russell Full Flow AN hose ends
Does anyone have one of the Russell Full Flow AN hose ends? I would like to get the measurement of the bore of fitting that slips into the end of the hose.
Aeroquip -6 fittings neck down to about 0.235" at the end that goes into the hose.
VaporWorx. We Give You Gas http://www.vaporworx.com
-
01-05-2008 #2
Registered User
- Join Date
- Sep 2004
- Location
- Kettering, OH
- Posts
- 537
I have a straight one and it measures .263 on the ID. I don't recall noticing any of them necking down in the ID (I've used plenty of -6, -8 Ts and elbows of the full flow swivle type).
1967 Firebird Convert, Fuel Injected 462 ci, TKO 600
http://1967firebird.atwebpages.com
01-05-2008 #3
-Moderator/Sponsor-
- Join Date
- Jun 2001
- Location
- Newbury Park, CA
- Posts
- 5,837
Thanks Hammered. Full Flow means something different to me than it does to the fitting manufacturers.
The teflon ends are worse, especially the 90*s.VaporWorx. We Give You Gas http://www.vaporworx.com
Reply With Quote
