Results 1 to 20 of 261
Thread: First-Gen S10 Corner Carver
Hybrid View
-
08-24-2009 #1
Registered User
- Join Date
- Dec 2006
- Location
- Out of the Burbs of Detroit to SoCal, then onto my ancestral homeland, the woods of Cascadia
- Posts
- 1,753
Thanks sinned
Greg Fast
(yes, the last name is spelled correctly)
1970 Camaro RS Clone
1984 el Camino
1973 MGB vintage E/Prod race car
(Soon to be an SCCA H/Prod limited prep)
-
08-30-2009 #2
Registered User
- Join Date
- Sep 2006
- Location
- New York, NY
- Posts
- 458
Memphis-machining done at Cope Brothers in Parkland/Spanaway. It's in the industrial park w/ the line-x on the side of 512
Sinned, I think in the pictures, there's roughly 1" left in the cup (I cut of 2 or so inches off the cup). The adjusters are turned so that the ring is seated on the cup, meaning it is as low as it will go without cutting more.
Full weight isnt on yet, so it will go lower than in the pictures.
Update on the status of the project - I started a job in July on the East coast, so there won't be substantial progress on the project within the next two years at least. It's a downer, but the project will get finished. I'll have a little bit of time at home during holidays, so there will be some progress, but not a ton.
Jerome
Reply With Quote
