First-Gen S10 Corner Carver

[jerome]

cab propped up ready for frame to roll under






interference with bellhousing




header fits in no way shape or form...the cab is still 2 inches too high in this pic


finally on there, resting on bellhousing still...took til nighttime, I did all putting the cab on by myself


some of the cutouts necessary for transmission clearance, showing cardboard mockup for firewall (clearanced for bellhousing)


closeup of firewall, little bump bottom left for clutch bracket on bellhousing that i'm not using


distributor goes in without the cap, but putting on the cap is a problem


but I can't cut too much out of the cowl, gotta clear the windshield wiper linkage


even with the cowl cut, still don't clear the wiper motor, need to rotate the wiper motor to clear distributor