Rocker advise

[67 Builder]

I am building a 67 camaro. And i'm installing a full floor pan.after cutting the old one out i realized that where the floor pan was spot welded to the inners there is a few rot spots that are "after diggig into them" are 1/2 tall and 1/1/2 long. The inner are very solid except for the spots descibed outside rockers have a few small holes where the trim screws were attached.. My questions is how do I get everthing sealed on the inside? after fixing the problems. I hate to take out the orignal rockers over a couple spots but i want this to be right. I thought about fixing the inners and replacing the outers so then I could get at the inside of the inners to get them sealed properly.Any advise please.

[merriman44]

changing rockers out is one of the easiest bodywork ive done so far. just brace and cut