Results 1 to 2 of 2
Thread: custom PCV / breather / system
-
06-12-2007 #1
Registered User
- Join Date
- Jun 2007
- Posts
- 35
custom PCV / breather / system
Looking for a cool set-up for a PCV/breather. Something like a circle track set-up. I have sheet metal valve covers without holes. I have seen a set-up with 10an bungs welded in the valve covers and braided lines going to the rear of the motor with a horizontal aluminum tank mounted to the firewall. A 10an fitting in each end of the tank with 2 K&N breather filters on the top.
Does this make sense?
Pictures of your custom set-up would be greatly appreciated.
Thank you,
Brent
-
06-12-2007 #2
Registered User
- Join Date
- Aug 2004
- Location
- Lees Summit, Missouri
- Posts
- 843
Check this one out, I was looking at doing something this way. I am note sure what he is doing now, but I got this picture and idea from Matt @ Lateral Dynamics (back when he was doing some stuff on the side).
Later - Craig
[email protected]
'70 Chevelle (in storage now, probably will never be back on its wheels again!)
Reply With Quote
