Hey Jeb

Welcome to the wonderful world of the ramjet! As you have probably already discovered you dealer is of no assitance. Hell so far the GM engineers ive spoke with dont even know a lot about the Ramjet. I have a 502 but the ecm is the same. If its fairly new you should have a mefi4 system. Have you checked it for codes? Mine had 2 codes i resovled one by replacing a bad relay supplied by chevy with the motor. And the other was an interference problem which may be causing the symptoms your car has. The 5 volt reference for the tps was out of range. I had wire tied the harness real neatly on the manifold. Once i removed the wire tie and moved the wires away from the ful rail my 5 volt reference became steady and my codes would reset. If you have no codes another problem that i am told gm is working on is the ISC is slow to react. GMs working on a solution but you will probably fix it yourself before the get a fix for it.



Theres not a lot of technical help out there for the ramjet. Mine has 1800 miles and still wont rev over 4000 rpm. Ive struggled with my dealer they have not been able to give me much help. They decided the codes meant it had a bad ecm. They gave me a new computer and told me that it had to be ran 5 hours until it would rev up. It seems to start and idle better with the new ecm but still cut out at 4000.

The most headway i made with it was with help from a tech that applied general fuel injection trouble shooting principles to my car. With his help i was able to clear all the codes but still no rev up.

I got some bum info from a couple reputable sources so im leary anymore. Its a shame my dealer doesnt even have a scanner for the ramjets. I bought my own it should be here tomm so ill update you if i find out whats up.

Good Luck John