Engine bay wiring...

[John S]

Well since none wants to join in and post pics I decided to go ahead and post mine anyway. I just finished the bulk of it tonight and still have some cleanup to do but it feels good getting the lions share done.

[John McIntire]

What I did was try and mount all of that stuff up under the dash somewhere in order to clean up the firewall. I ran my wiring mostly through hole that I made through the trans tunell, so that any wire that did come out, was low and below deck hight and towards the center of the car. This way it really isnt visible from most angles.
I ran my injector harness similiar to yours, except I spun the injectors around 180 degrees so the plug is actually between the fuel rail and plenum.
My engine compartment is all black, and I used that black nylon sleeving that you have for just about everything in order to hide things and tidy up things at the same time.

[jy211]

Try and hide it all...use heat wrap.

[Mark Smith]

I agree with the keeping it tidy theory.dosent cost anymore to put a little pre planning into it and really make it look nice.ive seen cars where you know the guy has spent alot of money on nice parts and such and then just stuck it on the car with out much forethought.