Results 1 to 4 of 4
Thread: pinion angle
-
12-16-2004 #1
Starting The Transformation
- Join Date
- Aug 2004
- Location
- california
- Posts
- 139
pinion angle
having lowered the rear suspension 2-3 inches on my 69 camaro what pinion angle do i want for correct allingment?
-
12-16-2004 #2
Registered User
- Join Date
- May 2002
- Location
- Northern California
- Posts
- 10,716
pinion
Anywhere from 3-7 degrees down would be a good place to start.Either wedge shims or reweld perches
MrQuick ΜΟΛ'ΩΝ ΛΑΒ'Ε
-
12-21-2004 #3
Registered User
- Join Date
- Aug 2004
- Posts
- 957
The pinion angle on the differential should be equal, but opposite to the angle on the output shaft of the transmission for a street or road race car. A really good target is three degrees, much more than that can have a negative impact on the lifetime of the U-joints. If the angles are not similar, you can get some very nasty harmonic vibrations, which will also kill your U-joints.
The drag race guys will have a different story, I know many alter the pinion angle to get better bite, but this is not recommended by any means for a typical application (non-strip).
Mark
Edit: Spelling
-
12-21-2004 #4
Starting The Transformation
- Join Date
- Aug 2004
- Location
- california
- Posts
- 139
yes makes sense and from what i been told you are right
Reply With Quote
