Calling CAMCO/Jody!

[Fluid Power]

Jody,

Your extensive knowledge of Fuel systems leads me to this question: What is your opinion of the "moon" system featured here:

http://69.20.111.53/index.asp?PageAc...OD&ProdID=1241



http://69.20.111.53/index.asp?PageAc...OD&ProdID=1245

Is that a reasonable price for that system?

Any comments and suggestions would be appreciated!

Comments by anyone else are also encouraged.

Thanks,

Darren

[Ralph LoGrasso]

Darren,

You have a PM.

Thanks,

[camcojb]

Darren,

It would be depend on your power goals. It's no doubt a beautiful setup. Would make very good torque too. I'd say it's fine to 500 HP or so on a small block. That's not set in stone but beyond that I'd guess it would be airflow limited.

So if you're planning on say a 475 HP 350 it should work well.

Jody

[Fluid Power]

The 450-500 hp is acceptable for me.

thanks for your reply!

Darren

[camcojb]

These guys also do downdraft and sidedraft Weber systems. Not sure how their price compares.

Inglese

Jody

[Fluid Power]

Jody,

The inglese systems are sweet but incredibly expensive compared to the moon stuff. It is almost as if the moon stuff is not priced right it is so much cheaper. I will have to make a call on Monday to see what is up.

I would love to do a side draft set up converted to efi. I passed on a carb setup at a swap earlier this year that was $450(!?) missing 1 carb. It was not a side draft manifold but more of the velocity stack style like your cobra. I was not thinking far enough ahead at the time.(even though it was a steal!!) By the end of the meet, I went back looking for it because I hadn't bought anything and it was gone. D'oh!

Thanks again for the feed back!

Darren