Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 17 of 17

    Threaded View

    1. #7
      Join Date
      Dec 2002
      Location
      Lost Wages, Nevada
      Posts
      2,684
      Country Flag: United States
      Quote Originally Posted by hardline_42
      Chicane says the best setup is solid bushings up front, pivots out back with sliders and recommends the Gulstrand FIA leafs with the Cat 5 setup.
      Well.... not exactly. I never said anything about the Guldstrand FIA springs. Now my own design..... that is a whole 'nother subject. Nor would I choose a slider type of pivot for the rear.

      On the other hand, my spring design takes a few pointers from Guldstrand spring but they are completely different.



      Quote Originally Posted by CarlC
      The primary reason I used the spherical bushings on both ends was to try and eliminate torsional loads on the spring. Perhaps I'm just being overly paranoid, but it's my attempt to keep the possibility of spring failure to a minimum.
      I wouldnt say paranoid.... Id call that, damn smart. Composite spring technology still has a long way to go and the implimentation of your design does much more than meets the eye. Lessening the possibility of failure is just plain common sense considering that you are one of the very few that put your chassis through the ringer as well as you do.

      Quote Originally Posted by jaybee
      What is the purpose of using stiff bushings in the shackles and rubber in the front eyes?
      Id have to say ride quality, less noise transfer and lateral stability within certain expectations.





    Advertise on Pro-Touring.com