Results 1 to 8 of 8
Thread: Help with T-56 details
Threaded View
-
09-21-2006 #1
Help with T-56 details
I picked up a T-56 that supposedly came out of a 1997 Z28. Now I am not real familiar with these (or any manual) transmission but some things I am noticing about this one seem to contradict things I've been told and read.
I am in the process of trying to figure out what else I am going to need to install this in my 86 Monte SS so I have a few questions.- it was my understanding that this tranny used a "puller" for a slave cylinder. But in looking at it I do not see how it pulls, in fact it appears to me that it actually pushes from the rear. Does anyone have a picture of how it actually mounts to the transmission?
- I was thinking of installing the Tilton hydraulic TO bearing, but the pictures I've seen of this I do not understand how the bearing plate would mount to this transmission?
- I am going to need a bell housing for this to mount to a Dart Little M block with a two piece seal, any suggestions on one.




-





Reply With Quote



