The BAD AST Project - Faze II

[astroracer]

We got a lot of little things done today. Mel worked on the rear tubs and inner fenders. Getting the inner sheet metal cleaned up and ready for self-etching primer. I want to get all of the inner sheet metal primed and painted before we weld the tubs in for good.
The right side is just about ready.

I still need to finish up the welding on the drivers side. It'll get there...

I was doing the same thing up front. I did make a change to the clearance pocket though. I cut out the inside edge of the pocket and smoothed it out with a flat piece of steel to get rid of the hard edge. Now, if the tire hits it, it will only see a flat surface. Much easier on the tire and wheel well.
This is the piece I made to smooth out the clearance bump.

Here it is all tacked in and cleaned up, ready for some primer and seam sealer...

Thanks for looking... I am kind of concerned though. My build thread gets a ton of views but no one says anything... Why is that?
Hello?
Guys?
Gals?