The BAD AST Project - Faze II

[astroracer]

Thanks Will! I have used that one for quite a while. You can also drill extra holes at whatever height you need. You can see a screw in the top I use to lightly clamp the pen in place. I ground down and rounded the point so it won't poke a hole in the sharpie.
We got a lot done today although it doesn't look like it. I spent two days cleaning out all of the old sheetmetal to make room for the new tires... Couldn't believe it.
Both sides are opened up now so I canactually get back to building...

I still have a lot of work to do to get the new tubs fit in but we'll get there.

Here is a pic of the drivers side tire at ride hgt.

Mel got the floor patch almost ready. He made the end plates and got everything fit up and clamped

After the fit up.

A lot of work here also.

This piece will get welded back into the floor and that original crossmember will give me a place to hang mufflers and stuff.

We still need to get it set into the floor so we can mark it for the K member notches. Lots to do, so little time...
Thanks for looking
Mark