The BAD AST Project - Faze II

[astroracer]

Thanks Will. Once these were ground down and smoothed out they look fantastic!
We also knocked off the caliper ears in preparation for the Corvette abutment brackets.
Outside view

Top View

inside View

Bottom View

Knocking off the old caliper "ears". We sawzalled the ears off at the felt pen lines.

All gone, blended and ready to drill and tap for 7/16-20 bolts.

This is the new abutment bracket in place before we did any cutting.

Thanks for looking.
Any thoughts on these arms?
Mark


I am open to all comments on these. I do have to admit they look a bit beefier than the orange one posted above.... I do know there is a lot more weld and actual "arm" supporting the new location.