Results 1 to 2 of 2
Thread: LED Shift Light
Threaded View
-
05-19-2006 #1
LED Shift Light
I recently rewired the entire car using a Ron Francis wiring kit and also installed LEDs for my turn signals and high beam. While I was at it I ran wire for a fourth red LED in the dash that I would like to use for a shift light. Is there any kind of controller that would run this LED for a shift light. Right now I currently run a MS 6AL, MSD 2 stage rev box (for trans brake and opertaes on MSD pills), MSD timing controller for adjusting timing for NOS runs at the track. Could I jumper off the 2 stage rev controller with a wire on the high "pill" to get it to light my LED or is there some other way of doing it with what I have. Or do I have to buy a control box of some sorts to operate the LED? Thanks
Justin
--------------------------------------------------
73 Nova, 502 ci, TKO600, Mosier Eng 12 bolt, 6 point roll cage, Wilwood rear discs, factory front discs, 250 HP nitrous, subframe connectors, Slide-a-link trac bars, 17" Boyd Coddington Smoothie II's, and Hotchkis TVS kit.





Reply With Quote



