Results 1 to 8 of 8
Thread: Request for bodywork tutorial
Hybrid View
-
04-26-2006 #1
Ive welded trim holes up. you usually start by sanding around the edge of the hole down to bare metal. then you clean the metal around it with a metal cleaner. then you begin welding starting on the edge of the hole (half on the metal, half off) like a 50/50 overlap and continue around the edge of the hole until its closed. kind of like a icecreamcone but not building up in the middle to high. small holes should only take 1or 2 passes and once it closed...leave the heat in the middle for a couple seconds and the build up will usually "drop" to be close to flush with the rest of the weld. dont hold it more than like 2 seconds or you will burn through.
colt zantop
1968 camaro LS1.......aka......."NJECTED"
-





Reply With Quote



